国产在线一区二区三区,夜夜笙精品麻豆7777,久久久久久91香蕉国产,蜜桃91丨九色丨蝌蚪91桃色
Welcome to Changzhou yuen machinery equipment co. LTD!
Hot Keywords:     Automatic single end terminal    Ultra static terminal    Strip and strip punch
NewsNEW CENTER
CONTACT USCONTACT US

Conatct:Mr Wu

Mobile:+Q:2223857802

Tel:+Q:2223857802

E-mail:898063083@qq.com

Add:4-2026, yikang electromechanical plaza, tianning district, changzhou city

NewsYour current location: Home > News
Automatic terminal maintenance and maintenance
Release:2018-04-19Browse 655 
Details

Daily maintenance of automatic terminal machine is very important, we can not to work for mechanical work, either with or machines have a certain load range, once beyond, over time can cause all sorts of problems, cut off machine service life. The daily maintenance of the fully automatic terminal machine has been completed, which can extend its service life and improve the working efficiency. Now let the mechanical equipment of atto introduce the daily maintenance and maintenance of the fully automatic terminal machine.

1. Mold mounting clamping must be accurate and firm. Mold clearance is reasonable, often keep sharp tool edge.

2. It is forbidden to overwork the machine. The punching pressure of the workpiece being processed shall not exceed the limit range.

3. Before starting the motor, the clutch must be disengaged and the flywheel should be in an idle position.

4. The lubrication points of the machine, as well as the friction parts, shall be lubricated frequently, no less than 2 times per shift.

5. Regularly check whether all parts of the machine are working normally, and whether all connectors and fasteners are loose. If loose, tighten it in time. If organic parts are found to be worn, they must be replaced promptly.

6. The machines and electrical equipment must be kept clean, dry and free of leakage. In work, if the fault and abnormal phenomenon is found, must immediately stop the machine for inspection and repair. It is prohibited to work with illness, so as to avoid causing greater losses such as machine parts biting to death or motor burning.

7. The fully automatic terminal machine shall be inspected and maintained regularly.

Attention should be paid to:

1. During the operation, if there is any abnormality in the machine, first turn off the power, and ask the mechanic to repair and debug in time.

2. When replacing the terminals, the power must be disconnected first and then replaced. It is strictly prohibited to replace the terminals in the operation of the machine.

3. During the operation, the power of the machine is not disconnected, and it is forbidden to enter the punching range of fingers or any part of the body, so as to avoid accidents caused by work-related injuries.

4. During the operation, if you need to leave your job, you must turn off the power before you leave.

5. In the operation, if there is a terminal stuck in the tool mold, it must be cleaned with scissors or pick needles before continuing the operation.

6. Non-designated personnel are strictly prohibited from debugging or disassembling machine parts by themselves.


Link: 常州360推廣
  Copyright  Changzhou yuen machinery equipment co. LTD  All Rights Reserved  【Login】
TopQQMegWechatBottom
QQ
點擊這里給我發(fā)消息
QQ
點擊這里給我發(fā)消息
Welcome to leave a messageClose
Contact:
Tel:
  
WeChat, scan, plus attentionClose
国产在线一区二区三区,夜夜笙精品麻豆7777,久久久久久91香蕉国产,蜜桃91丨九色丨蝌蚪91桃色